909 54 606 post@ledx.no

Programmable High bay (SW03-2018)

Specification

Voltage: Suitable for mains voltage 100 – 260Vac, 50Hz (switch mode).
Loading: Suitable for switching and dimming DALI ballasts (broadcast only) and can control up to 40mA, eg. 20 ballasts at 2mA (varies according to make and model of ballasts).
DANLERS DALI Power Supply Unit is rated at 40mA (DALI standard allows 250mA maximum). The controls interface of a DALI ballast normally sources at 2mA. Please refer to your ballast instructions.They can also switch up to:

  • 10 amps (3000W) of resistive loads
  • 6 amps (1500W) fluorescent lamps, high frequency or switch start, incandescent or mains halogen lamps (recommended with integral safety fuse)
  • 3 amps (750W) of electronic or wire wound transformers.
  • 2 amps (500W) of low energy lamps: CFL, LED drivers and LED lamps and fittings.
  • 1 amp (250W) of fans or most metal halide lamps.
Minimum load: 2W resistive, suitable for most energy saving lamps, LED’s and emergency fittings.
Time Lag: Can be easily adjusted by APP to individual requirement from 10 seconds to 23 hours 59 minutes 59 seconds
Short Visit Time: Can be easily adjusted by APP to individual requirement from 10 seconds to 23 hours 59 minutes 59 seconds
Lux: Enabled: 30 to 1000 lux and infinite lux (photocell inactive).
Sensitivity: Adjustable via APP.
Output: Mains switching or DALI switching functionality.
Dimensions: Device: 90mm diameter x 63mm
Power Supply: 120 x 50x 32mm
Prisforespørsel
Kategorier: ,

Relaterte produkter